Skip to content
DELTMAX
Delt ScoreRatio calculatorGuidesPricingFAQ
Get Deltmax
  1. Home
  2. Guides
  3. Uneven shoulders

DELT GUIDE

How to fix uneven shoulders

Most delt imbalances shrink with one-arm training. Here's how, and when to get it checked.

Small differences between your left and right delts are normal. To even them out, switch some work to one arm at a time, start each set with your weaker side, and match its reps on the stronger side. Deltmax's 4-week Balance Fix plan is built this way.

What the Deltmax scan looks at

Your Symmetry sub-score compares how far your left delt extends past its joint with how far your right one does. A perfectly even split scores 100; a 52/48 split scores 84. It's 15% of your Delt Score.

The scan rejects photos where your shoulders tilt more than 15°, but a slight lean, twist or uneven light can still nudge symmetry. Scan facing the camera squarely, in even light.

What to train

This is the Balance Fix plan Deltmax assigns when this is your lowest sub-score. It runs 4 weeks, rotating the sessions below 2 to 5 times a week, with a re-scan checkpoint every two weeks. Every lesson has a full-gym, dumbbells-only and no-equipment version.

Left = Right

Full gymSets × repsDumbbells onlyNo equipment
Single-arm cable lateral raise4 × 12–15Chest-supported dumbbell lateral raiseWall handstand lateral shift
Single-arm landmine press3 × 8–12Alternating dumbbell shoulder pressPike push-up
Single-arm cable reverse fly3 × 12–15Dumbbell rear delt rowProne Y-T-W raise

Even Caps

Full gymSets × repsDumbbells onlyNo equipment
Single-arm cable lateral raise3 × 12–15Chest-supported dumbbell lateral raiseWall handstand lateral shift
Cable upright row3 × 10–15Dumbbell upright rowPike push-up
Single-arm cable reverse fly3 × 12–15Dumbbell rear delt rowProne Y-T-W raise

How to make it work

  • Start every one-arm set with the weaker side, then do the same reps, no more, on the stronger side.
  • Use the same weight on both sides, set by what the weaker side can do with good form.
  • Slow the lowering part down on the weaker side and pause at the top to feel it working.
  • Re-scan after the 4 weeks. If the gap has closed, go back to a regular plan.

Common mistakes

  • Adding lots of extra sets for the weaker side for months. A small amount of extra work is plenty; the rep-matching does most of it.
  • Letting the strong side take over during two-arm presses and raises.
  • Blaming a posture, camera angle or lighting problem on muscle size.
  • Ignoring pain, a sudden change, or a big difference that doesn't improve. Those deserve a check with a doctor or physiotherapist.

Track it

Re-scan every two weeks in the same spot, light, clothing and pose, and compare sub-scores rather than single photos. Small changes of a few points can come from lighting or posture alone, so look for a trend across several scans. See how the Delt Score works for what each number means.

Keep reading

CAPSHow to get rounder delts

Build the side delts that make shoulders look round from the front.

WIDTHHow to get wider shoulders

Add width to your frame with side delts, rear delts and lats.

V-TAPERHow to get a V-taper

The two levers: wider shoulders and a smaller waist.

FREE TOOLShoulder-to-waist ratio calculator

Your ratio and the gap to 1.618.

This is general training information, not medical advice. Warm up, use loads you can control, and stop any exercise that causes sharp or joint pain. If you have an injury or a health condition, check with a qualified professional first.

Find your weakest delt area

Scan your shoulders in seconds. Your lowest sub-score picks your plan.

Get your Delt Score ↗
DELTMAX

Scan your delts. Build them.

PRODUCTHow it worksHow the Delt Score worksPricingDeltmax vs AbMaxx
TOOLS & GUIDESShoulder-to-waist ratio calculatorAll delt guidesRounder deltsWider shoulders
HELPFAQSupportContact
LEGALPrivacyTerms
© 2026 Deltmax (formerly Apevo). All rights reserved.Built for boulder shoulders.